Adjust colour of Connector across multiple pages

[dhodgson7]

Hi all, is it possible to Adjust the colour of a Connector across multiple pages ?

I have 1 connector in page1
I have 1 connector in page2
I have 1 connector in page3

I'd like to select the connector in page1, change it to red and the connectors in page2 and page3 all change to red.

I will end up have hundreds of lines on each tab but I'm only ever going to select one from each tab at a time.

This is for a network wiring diagram which shows each network rack as a page, the cables (connectors) go through multiple racks before the source and destination devices are connected. Instead of having too much information on a single tab I'd like to break it up into multiple tabs but still be able to "follow" a cable across all the equipment it connects to, i.e. switch, fobot, fobot, switch.

[TwoBeAss]

You need to set references in the shapesheet to your connector on page1.

e.g. LineColor Cell: =Pages[page-1]!Sheet.5!LineColor

Better GUARD that Formula to not accidentally change the color...

[dhodgson7]

thanks for your answer, however would there be an easier way ? I would have multiple users doing this and I would like to keep it as simple as possible.

Also on retrospect I'd like to be able to select the connector from any page and change it's colour.

[Thomas Winkel]

Possible with ShapeSheet only.
See attached Visio.
I assume that your connectors have a property for the net name.

You cannot view this attachment.