More concurrently active glue points

[domju]

Nice day,

I was not able to determine if it is, look at the picture.

1. it's okay 1D - it does not glue points
2. In every corner of the glue point, but saves only one other does not
3 It is something to do to adhere and appeared three other glue points

Thanks for any advice

[Surrogate]

Because quite enough only one active glue point !!! 

[domju]

Because quite enough only one active glue point !!! 

Okay, I understand, however, is not a possibility? Some? Macro or something?
Maybe custom sheet?
Enough would mean to me.

[Surrogate]

Only one page can be active per document.
Only one window can be active per application.
Only one document can be active per application.
Only one application can be active per ms windows© OS.

[domju]

Only one page can be active per document.
Only one window can be active per application.
Only one document can be active per application.
Only one application can be active per ms windows© OS.

I knew that the perfidy on the part of firms.    Even so, thank you for your answers, much helped me.

[Surrogate]

IMHO it is impossible set some active glue points.
Also by default Visio have limitation - look at VisGuy's article When 2D Glue Breaks

[vojo]

FWIW....I use lots and lots of connection points per shape....I think you can set them to type 3, I think that would allow
shapes.  Only caveat is that 2 shapes cannot be bound by more than 1 point

May be worth exploring for you needs

[domju]

IMHO it is impossible set some active glue points.
Also by default Visio have limitation - look at VisGuy's article When 2D Glue Breaks

These articles I read, but does not solve my problem, I do not reentrant, I want to make me the glue points emerged as the figure third position
So far I see it, that's impossible

P.S. This is a pretty good score, an article came out in 2007 and is still not regulated 2D

[domju]

FWIW....I use lots and lots of connection points per shape....I think you can set them to type 3, I think that would allow
shapes.  Only caveat is that 2 shapes cannot be bound by more than 1 point

May be worth exploring for you needs

Unfortunately, while I found out that there are only three possible types of glue points 0, 1, and 2.
Only Info Glue can be set GlueType 0, 1, 2, 4 and 8, but 3 I never found, so it would be better to direct me?