Visio 2010 SDK - Developer Tab Extension "Print Shapesheet" - disabled

[aland]

After Installation of Visio 2010 SDK - the Developer Tab Extension was added to my Visio Professional.
But it is disabled (greyed) and I cannot use such functions as"Print Shapesheet" and "Event Monitor"
How to enable this functions in the Developer Tab?

[Paul Herber]

Have you enabled developer mode?
File -> Options -> Advanced -> General section

[aland]

Yes. I've tried. The same result: "Print Shapesheet" and "Event Monitor" are still disabled

[Paul Herber]

Ah, is everything in the Developer tab greyed out, or just these two in particular? What about Persistent Events?

[aland]

"Persistent Events" is also greyed out. But other items on developer tab are working normally.
By the way, this three buttons "Persistent Events", "Print Shapesheet" and "Event Monitor" were hidden.
I've added them manually to the bar by customising when I read about them in one article.

[Paul Herber]

I think that's the clue then, when the SDK is sinstalled those items should be added to the tab, they shouldn't need to be added manually. Try removing them, close Visio, uninstall and then reinstall the SDK.
Question: was Visio running when the SDK was installed?

[Jumpy]

Or don't they run with 64bit Visio?

[Paul Herber]

Or don't they run with 64bit Visio?

That's a very good point!

[aland]

I have windows 7 x64 and Visio 2010 Prof x32
I've just reinstalled Visio 2010 SDK.
no effect.