Ruler settings in Vision 2010 Org Chart

[sheilagarner]

I have a multiple sheet org chart that I am working on and have a question regarding the position shape on each sheet.  I have made sure that the top shape on each page is on the same X and Y axis for consistency.  However, there is one sheet (out of 35) where this does not work.

On every other sheet, the top position is X=5.5 (center of landscape orientation on letter size page) and Y=7.0 (1.5 inches down from top of page).  However when I try to replicate these settings on this particular sheet, the top-most shape and all attached to it jump to the right, making it look like it will need to print out on legal paper.

Upon closer inspection, I notice that the ruler at the top of the page is offset to the right by 2 1/2 inches.  I have tried to make sure that my paper size and drawing page size are all set to 8.5 X 11 landscape, but no luck...

Any help is appreciated!