Author Topic: When Saving as DWG, Fills should translate to bhatch  (Read 3157 times)

0 Members and 1 Guest are viewing this topic.

visProcessEng

  • Jr. Member
  • **
  • Posts: 20
When Saving as DWG, Fills should translate to bhatch
« on: June 26, 2008, 11:42:11 PM »
I have just finished adding (Manually) hatch patterns that reside under my fill patterns (for normally closed valves on P&IDs).  The valve is closed via Shape Data value, and the fill and hatch pattern is shown in visio.

When saved as a dwg, only the hatch pattern translates to the dwg.

This would not have been too difficult except that the translation package was not able to figure out the logic.