Print Page - Auto connect not working. I checked if it was off and it's on..

Title: Auto connect not working. I checked if it was off and it's on..
Post by: surferdude949 on January 14, 2010, 12:36:57 AM

I'm working on a flow chart diagram and the auto connect is not working as I hover the pointer over the shape.

I checked if auto connect is off and it's set on "enable".

The weird thing is that I open another network diagram and auto connect works fine there.

Any ideas? ???

Title: Re: Auto connect not working. I checked if it was off and it's on..
Post by: Barry on February 01, 2010, 06:41:29 AM

Open the document stencil for the flowchart document and find the dynamic connector master. Open the master and look at its shapesheet. Verify that the GlueType cell in the GlueInfo section is set to 2 (visGlueTypeWalking.)

Let me know if that still doesn't work and we'll dig deeper...

-Barry

Visio Guy

Visio Discussions => General Visio => Topic started by: surferdude949 on January 14, 2010, 12:36:57 AM