Hello,
I like to put rectangles and have the corners snap only to visible lines. I have looked at View->Visual aids->General and put a check in the currently active snap and the snap to grid. When I drag rectangles around, I can leave them on locations that arethe grid lines and also locations that are not the grid lines. Is there a way to make it go only on the grid lines?
Also, the quantity of grid lines change as I zoom in and out. Is there a way to force them to be always the same distance in mm apart?
Thanks
align ==> snap to grid
There is also a more manual way...I have to dig up
If I recall, its something like
user.x = setatref(pinx, rounddn(pinx,0))
basically, it gets current pinx and rounds it down to integer then place result back in pinx
user.y = setatref(piny,rounddn(piny,0))
also
http://www.visguy.com/2019/09/11/hex-snap-glue-shapes/
Couple additional points...
In the Visual Aids section, you may want to deselect the Ruler snap to option, or, open the Advanced tab and set it's strength to be 0 or very small.
Now, expand the Show section to bring up the Ruler & Grid menu window. You can change the Horizontal and Vertical Grid spacing using the pull-down menus. There is choice to set to Fixed. You must also set the Minimum Spacing to be something other than zero.
Don't believe there are any additional, pertinent settings.