I am new to visio and I have been playing around with electrical contacts. I have found how you can change the contact for open to close. Is there a tutorial out there that could show me how this is done? I want to make a switch the when "switched" will change various contacts across the drawing. I was looking at the dip switch tutorial but its a little complicated. Is there a recommended reading or readings out there to build up my knowledge level in this area?
Thanks for your help.
This might help:
http://www.paulherber.co.uk/articles/visio-articles/connected-shapes/ (http://www.paulherber.co.uk/articles/visio-articles/connected-shapes/)